6D45F11
3-8
9
8
7
6
5
4
3
2
1
Power unit/Control system
NOTE:
If the starter rope cannot be pulled out, the
start-in-gear protection is working correctly.
3.
Set the shift lever and or remote control
lever in the neutral position and loosen
the locknut
1
. Align the wire end
2
with
the mark
a
on the starter case to adjust
the cable adjuster
3
.
Adjusting the throttle cable
(For tiller control model)
1.
Check that the throttle cables for smooth
operation, looseness, fraying or damage.
Replace if necessary.
2.
With the throttle grip in the fully closed
position, check that the stopper on the
pully, comes in contact with the throttle
stopper plate. Adjust if necessary.
3.
Loosen the locknut
1
and adjust the
length of the throttle cable (pull-side)
2
with the adjusting nut
3
until the stopper
4
on the pully contact the stopper plate
a
on the bracket, then tighten the lock-
nut.
4.
Turn the throttle grip to the fully closed
position.
5.
Loosen the locknut
5
and adjust the
length of the throttle cable (push-side)
6
with the adjusting nut
7
until the stopper
8
on the pully contact the stopper plate
a
on the bracket, then tighten the lock-
nut.
6.
Fully open and close the throttle grip and
make sure the stopper on the pully con-
tacts the stopper on the bracket (at the
fully opened position) and stopper on the
bracket contacts the stopper on the pully
(at the fully closed position). If proper
contacts are not made, repeat the proce-
dure.
6D430190
a
1
2
3
1
2
3
4
a
6D430220
6
a
8
7
5
6D430230
6D45F11-03 03.10.9 20:43 Page 9
