4.
Check the interior
b
and the exterior
c
of the timing belt for cracks, damage, or
wear. Replace if necessary.
c
C
Do not turn the flywheel magnet counter-
clockwise, otherwise the valve system
may be damaged.
Replacing the timing belt
1.
Turn the flywheel magnet clockwise and
align the “1” mark
a
on the driven
sprocket with the “
▼
” mark
b
on the
cylinder head,and then remove the timing
belt.
NOTE:
At the same time, check the cut out
c
on the
driven sprocket with the “
▲
” mark
d
on the
cylinder block is aligned.
CHK
ADJ
3-5
6D45F11
Periodic checks and adjustments
3.
Install the oil filter, and then tighten it to
the specified torque.
Checking the timing belt
1.
Remove the manual starter and cover.
2.
Turn the flywheel magnet clockwise to
transfer the slack
a
of the timing belt
from port to starboard and hold the fly-
wheel magnet.
3.
Slightly push the timing belt with your fin-
ger between the drive sprocket and dri-
ven sprocket, and then measure the belt
slack. Replace if necessary.
6D430080
6D430090
a
b
a
6D430110
6D430100
b
c
Oil filter wrench:
90890-01426
Oil filter:
18 N·m (1.8 kgf·m, 13 ft·lb)
Specified slack
a
:
Less than 10.0 mm (3.9 in)
6D430115
c
d
6D45F11-03 03.10.9 20:43 Page 6
