Yamaha CS1D, Operating Manual

Page: 141 / 630

Chapter 5. Basic operation for output channels
69
Basic operation of the MATRIX OUTPUT block
This section explains basic operation of the MATRIX OUTPUT block.
Controls and functions of the MATRIX OUTPUT block
Sending a signal from a MATRIX channel to an output unit
Here’s how the signal sent from a MIX channel or the STEREO A channel to the MATRIX bus can be output from an
output unit patched to the corresponding MATRIX channel.
[Procedure]
1. Make sure that an appropriate signal is being sent
from a MIX channel or the STEREO A channel to a
MATRIX bus. Also make sure that a valid output
unit is patched to the corresponding MATRIX
channel.
2. In the MATRIX OUTPUT block, turn on the
MATRIX [ON] switch for the MATRIX channel.
3. In the MATRIX OUTPUT block, raise the MATRIX
[LEVEL] encoder.
The signal of the corresponding MATRIX channel
will be output from the output unit patched to that
channel.
4. So that the (post-fader) signal sent from the
MATRIX bus to the output unit can be monitored
in the meter bridge, go to the METER section in the
MASTER block of the console, turn on the METER
SELECT [MATRIX 1-24] switch and turn off the
METER [PRE] switch.
With these settings, the 24 meters at the right of the
meter bridge will indicate the post-fader signal levels
of the MATRIX channels.
PAIR
ON ON
MATRIX [NAME] indicator
This displays the short name of the MATRIX
channel.
MATRIX [ON] switch and LED
This switch turns the MATRIX channel on/
off. If this switch is off, the signal will not be
sent to the output unit patched to the corre-
sponding MATRIX channel.
MATRIX [LEVEL/BAL] encoder and LEDs
These encoders set the output level of
each MATRIX channel 1–24.
[INS] LED
This LED will light when insertion is on for
the MATRIX channel.
MATRIX [CUE] switch and LED
This switch monitors the currently selected
MATRIX channel.
SAFE [RCL] LED
This LED will light for MATRIX channels that
are set to Recall Safe (a condition in which
the channel is independent of scene recall
operations).
SAFE [MUTE] LED
This LED will light for MATRIX channels that are
set to Mute Safe (a condition in which the chan-
nel is independent of mute group operations).
MATRIX [PAIR] LED
This LED will light for adjacent odd-numbered
→
even-numbered MATRIX channels that are
paired.
MATRIX [SEL] select and LED
This switch selects the MATRIX channel that
will be controlled. The MATRIX [SEL] LED of
the currently selected MATRIX channel will
light.
MASTER block
METER [PRE]
switch
METER SELECT
[MATRIX 1-24]
switch