CS1D Operating Manual (Basic Operation)
136
Controlling a graphic EQ
To control a graphic EQ, you can either use the virtual faders and virtual knobs shown in the display, or the DCA faders
of the CS1D console.
Controlling a graphic EQ from the display
Here’s how to control the desired GEQ module by using the virtual faders and virtual knobs shown in the GEQ function
screen.
[Procedure]
1. In the LCD FUNCTION ACCESS block, press the
[GEQ] switch several times to access the GEQ
PARAMETER screen.
•
GEQ PARAMETER screen (GEQ function)
2. Click the MODULE button located in the upper left
of the screen to select the GEQ module that you
wish to control.
Make sure that the GEQ ON/OFF button is turned
on. Also make sure that the corresponding module
has been inserted into an appropriate channel, and
that insertion has been enabled for that channel.
Hint
An alternate way to select the desired GEQ module is
to use the GEQ ASSIGN 1-12/13-24 screens of the
GEQ function.
3. Use the LIMIT section (located in the screen at the
right of the faders) to specify the range of the fad-
ers.
In the LIMIT section you can select the maximum
change and direction of change produced by the fad-
ers. You can select ±15 dB, ±12 dB, ±6 dB (these are
bi-directional, allowing boost or cut), or –24 dB (cut
only).
•
LIMIT section
4. Operate the virtual faders in the screen.
The numerical boxes below the faders will indicate
the amount of boost/cut.
Hint
By clicking the EQ FLAT button located below the
LIMIT section, you can reset all faders to the 0 dB
position.
5. As necessary, operate the four notch filters located
at the bottom of the screen.
Four notch filters can be used for each GEQ module.
The NOTCH 1 – NOTCH 4 buttons turn each filter
LCD FUNCTION ACCESS
block
[GEQ] switch
Summary of Contents for CS1D
