Yamaha CS1D, Operating Manual

Page: 295 / 630

SELECTED OUTPUT CHANNEL block
65
DCA section
This section assigns the currently selected MIX channel to a DCA group. If you wish to assign a single MIX channel to
multiple DCA groups, it is convenient to use this section.
1 DCA [9]–[12] switches and LEDs
These switches assign the currently selected MIX
channel to DCA groups 9–12.
When the channel is assigned to a DCA group, the
LED of the corresponding switch will light.
This section is valid only when a MIX channel 1–48
is selected.
[Procedure]
Using the SELECTED OUTPUT CHANNEL block
to assign a MIX channel to a DCA group
1. Select the MIX channel that you wish to assign to a
DCA group (9–12).
2. Use the SELECTED OUTPUT CHANNEL block
DCA [9]–[12] switches to select the DCA group(s)
that you wish to assign to the channel. (You may
select more than one.)
The LED for the selected DCA group(s) will light.
•
DCA groups 9–12 can be used for either input chan-
nels or output channels (MIX channels).
However, it is not possible to assign both input chan-
nels and output channels to the same DCA group.
For this reason, if a input channel is already assigned
to DCA group 9–12, attempting to assign a MIX
channel will cause a message to be displayed, and you
will not be able to do so.
•
When a scene is recalled, the DCA group data of
recall safe channels may be adjusted so that recall safe
settings are consistent within DCA groups 9–12.
Also when a channel library is recalled, the data
recalled to a channel may be adjusted so that settings
are consistent within DCA groups 9–12.
12
11
10
9
DCA
1