Product Guide
VESDA ECO Detector by Xtralis
iv
17898_05
Codes and Standards Information for Air Sampling Gas Detection
We strongly recommend that this document is read in conjunction with the appropriate local codes and
standards for gas detection and electrical safety. This document contains generic product information and
some sections may not comply with all local codes and standards. In these cases, the local codes and
standards must take precedence. The information below was correct at time of printing but may now be out
of date, check with your local codes, standards and listings for the current restrictions.
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, the user is
encouraged to try to correct the interference by one or more of the following measures; re-orientate or
relocate the receiving antenna, increase the separation between the equipment and receiver, connect the
equipment to a power outlet which is on a different power circuit to the receiver or consult the dealer or an
experienced radio/television technician for help
Canada
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe
B
est conforme à la norme NMB-003 du Canada.
EU Directive 2004/108/EC – EMC Directive
This equipment has been independently tested for compliance with the requirements of the harmonized
standard
EN 50270:2006 -
Electromagnetic Compatibility – Electrical apparatus for the detection
and measurement of combustible gases, toxic gases or oxygen.
Electrical Safety
The ECO Detector has been designed to meet the performance requirements of the following standards for
electrical safety.
EN 61010-1:2001 -
Safety requirements for electrical equipment for measurement, control
and laboratory use. General Requirements
.
Gas Detection
The ECO Detector has been designed to meet the performance requirements of the following standards for
gas detection.
EN 50271:2002 -
Electrical apparatus for the detection and measurement of combustible
gases, toxic gases or Oxygen – Requirements and tests for apparatus
using software and/or digital technologies.
EN 50104:2002 -
Electrical apparatus for the detection and measurement of Oxygen –
Performance requirements and test methods
EN 45544:2000 -
Workplace atmospheres – Electrical apparatus used for the direct
detection and direct concentration measurement of toxic gases and
vapours
