VESDA ECO Detector by Xtralis
17898_05
Installation
Electrical Installation
Any installation of an ECO gas detector must comply with local electrical
safety regulations. If any of the following instructions conflict with the
local regulations governing the installation site, consult you
for advice.
Access on the ECO product for electrical connections is made by passing a suitable
cable (see below) through one of the two cable glands provided on the exterior of
the ECO enclosure, but before doing this the detector cover must
expose the connection terminals.
Electrostatic discharge precautions need to be taken prior to removing
the lid from the detector otherwise damage may occur to the unit.
To gain access to the electrical connection terminals the enclosur
be removed. Before removing the cover, ensure that there is no opportunity for
water ingress into the detector once the IP seal has been broken. Removing the
cover is achieved by pressing the fixing latch (A in Figure 4 below)
the cover and pulling the cover upwards. The cover should swing upwards from the
hinge (B) on the opposite side of the enclosure, from which the cover
detached by simply sliding it away from the body of the product.
Be careful to ensure that the seal within the edge of the cover is retained
and protected from damage whilst exposed.
Figure 4. Detector Internal Connector Identifications
Product Guide
11
Any installation of an ECO gas detector must comply with local electrical
safety regulations. If any of the following instructions conflict with the
local regulations governing the installation site, consult your distributor
Access on the ECO product for electrical connections is made by passing a suitable
cable (see below) through one of the two cable glands provided on the exterior of
, but before doing this the detector cover must be removed to
Electrostatic discharge precautions need to be taken prior to removing
the lid from the detector otherwise damage may occur to the unit.
To gain access to the electrical connection terminals the enclosure cover must first
Before removing the cover, ensure that there is no opportunity for
water ingress into the detector once the IP seal has been broken. Removing the
below) on the side of
should swing upwards from the
cover can then be
Be careful to ensure that the seal within the edge of the cover is retained
Detector Internal Connector Identifications
