K021 Instructions v1.0
Bag D
Page 26
D4)
Remove the two idler gears (ASC 9360) and four 3/16” X 3/8” metal shield
bearings (6202) from Bag D. Install two bearings in each gear, one from each
side. If a bearing is hard to install, we suggest pushing it with a socket or hex
driver where the O.D. of the socket matches the diameter of the outer race of the
bearing so you do not push on the balls or the inner race of the bearing. (right
photo)
D5)
Remove the two idler shafts (5201) from Bag D and slide them through the
bearings on the idler gears. Then install the shafts with their gears into their
bosses in the left transmission case half. Be certain to mesh all the gears
properly.
D6)
Install a 3/8” X 5/8” rubber sealed bearing (6203) over both outdrives of the diff.
