K021 Instructions v1.0
Bag B
Page 12
BAG B
COMPLETE THE FRONT END
SERVO SAVER
B1) Before proceeding with Bag B, please note: AE instructions tell us to put grease
on the joint between the servo saver bellcranks. Many X Factory Team drivers
do not. The problem with the AE servo saver is too much movement, not too
little. In fact, many Team drivers CA glue the two bellcranks together. This
increases the risk of either damage to the servo, breaking the bellcranks, or
breaking the servo horn, but you’ll get a much more direct feel to the steering.
Some drivers complain their car is pushing when the real problem is movement
in the servo saver assembly.
B2)
Remove the bag of plastic steering parts (ASC 9659) and the bag of servo saver
hardware (ASC 9610) from Bag B. Based on the above, put a bit of grease on
the lower servo saver bellcrank where it rides against the upper bellcrank.
(center photo) Or not. Put the two parts together. (right photo)
B3)
Place the two thin shims in the upper servo saver bellcrank as shown in the right
photo.
