Xerox WorkCentre 5020, System Administrator Manual

Page: 48 / 130

6 Printer Environment Settings
48
USB Port Installation
Follow these installation procedures for using the machine on a USB port.
Installation Procedure
There are three stages required to install the machine on a USB port.
USB Port Communication Setup
This requires the machine to be set up for USB port printing.
Computer Setup
This requires the computer to be configured to print to the machine.
Test Print
A print job should be submitted to make sure that the machine has been installed and
configured correctly.
USB Port Communication Setup
This section describes how to set up USB communication on the machine. The
following parameters can be set depending on your requirements. These setups must
be done without the USB cable connected.
This procedure is used to set up the USB communication parameters for the machine.
Perform the following steps using CentreWare Internet Services.
Initially, boot the USB port.
1.
Open your web browser, and enter the machine's IP address in the [Address] box
to access CentreWare Internet Services.
2.
Click the [Properties] tab.
3.
Click the [Connectivity] folder, and then [Port Settings].
4.
Select the [Enabled] check box for [USB] to enable the USB port.
NOTE: Confirm that the SNMP port is enabled. If not enabled, select the [Enabled]
check box for [SNMP]. For information on how to configure SNMP settings, refer to
SNMP Configuration on page 49
.
5.
Click [Apply].
6.
If prompted, enter the System Administrator user ID and passcode, and click [OK].
NOTE: By default, the System Administrator user ID is "11111" and its passcode is not
set.
NOTE: You can also enable the USB port on the Control Panel of the machine in the
System Setting Mode. For more information, refer to
System Settings on page 109
.
Depending on your requirements, set [Auto Eject Time], which allows you to specify the
time when the paper will be automatically ejected from the machine if no data are sent
to the machine. Follow these steps.
1.
On the [Properties] tab, click the [Physical Connections] folder, and then [USB].
2.
Set [Auto Eject Time] within the range of 5 to 1275 seconds in 5 second
increments.
3.
Click [Apply].