Xerox WorkCentre 5020, System Administrator Manual

Page: 46 / 130

6 Printer Environment Settings
46
4) Click [Apply].
5) If prompted, enter the System Administrator user ID and passcode, and click
[OK].
NOTE: Click the [Reboot Machine] button when it is displayed. If the [Reboot
Machine] button fails to be displayed, click the [Status] tab and then click the [Reboot
Machine] button.
NOTE: If the machine is rebooted, all scanned data stored in the mailboxes will be
deleted.
Computer Setup
Install print drivers on each client computer that will be sending print jobs to the
machine, and map to the machine as a printer. Refer to the PCL Print Driver CD-ROM.
Test Print
To make sure that the machine has been installed on the network correctly, a test print
should be submitted from each client computer. Perform the following steps.
1.
Open a document on a client computer.
2.
Select the machine as the printer to which the selected document will be sent.
3.
Print the document on the machine and verify that it prints correctly.
4.
Make sure that the driver is installed on every computer that will be sending jobs
to the machine.
5.
Repeat the test for all computers that will be sending jobs to the machine.
The installation process is now complete.
If the test print fails, refer to
Problem Solving on page 75
.