Xerox Versant 2100, User Manual, Page: 273 / 296

5. Reinsert the empty container into the machine.
6. Close the right cover on the finisher.
Note
A message will display and the machine will not operate if the right cover is open
even slightly.
Problem Solving
Fault Codes - Standard Finisher Plus
If a fault occurs in the Standard Finisher Plus, a fault message displays. The following
table provides a list of fault codes for this finisher module and of related Transport and
3rd party DFA fault codes.
Recommended Solution Possible Cause Fault Code
Check for any obstructions or paper jams
in the Finishing Module and Finishing
Transport paper paths and clear them.
If necessary, power Off / On the press
and resend your print job. If the fault
persists, contact the Customer Support
Center. The sensor or exit sensor in the
Finishing Transport did not
switch ON or did not switch OFF
within a specified amount of
time 013-108 to 013-110
Check for any obstructions or paper jams
in the Finishing Module and Finishing
Transport paper paths and clear them.
If necessary, power Off / On the press
and resend your print job. If the fault
persists, contact the Customer Support
Center. Paper jam at the transport
sensor or exit sensor (Finishing
Transport) 013-910, 013-911
Check for any obstructions or paper jams
in the Finishing Module and Finishing
Transport paper paths and clear them.
If necessary, power Off / On the press
and resend your print job. If the fault
persists, contact the Customer Support
Center. Paper jam 051-100 to 051-111,
051-900
18-13 Xerox ® Versant ® 2100 Press
User Guide
Standard Finisher Plus