REP 1.6 Rear Cover
Parts List on PL 1.2
Removal
1. Remove power cord.
2. Remove document catch tray assembly
(REP 1.1).
3. Remove output tray assembly (REP 1.5).
4. Remove rear cover.
a.
Remove the two screws securing rear
cover to the power supply housing.
b.
Rotate the top edge of rear cover
towards the rear to clear printer
output drive roller.
c.
Lift rear cover up and out of cutouts
in power supply housing.
Replacement
Reinstall in reverse order.
REP 1.7 Upper Scan Cover
Parts List on PL 1.2
Removal
1. Remove power cord.
2. Remove document catch tray assembly
(REP 1.1).
3. Remove coupler cover (REP 1.3).
4. Remove LH cover (REP 1.4).
5. Remove scan support assembly.
6. Remove control panel assembly (REP 5.1).
7. Remove upper scan cover.
a.
Remove the two screws securing
upper scan cover.
b.
Remove upper scan cover.
Replacement
1. Position the two locating pegs on upper
scan cover into the two locating holes.
2. Ensure W4 wire harness is not pinched by
the upper scan cover.
3. Reinstall in reverse order.
REP 1.8 Lower Scan Cover
Parts List on PL 1.2
Removal
1. Remove power cord.
2. Remove document catch tray assembly
(REP 1.1).
3. Open and secure scanner.
WARNING
Do not bump the scanner after it is secured.
The scan support assembly will release and
cause the upper scan assembly to pinch you.
4. Remove lower scan cover.
a.
Release the latch securing lower scan
cover to LH frame.
b.
Release the latch securing lower scan
cover to RH frame.
c.
Pull lower scan cover gently forward
to clear video assembly, then raise it
to clear lip of base plate.
Replacement
Reinstall in reverse order.
6/88
Telecopier 7017 / 7017SF
4-5
REP 1.6, 1.7, 1.8
www.printcopy.info
www.printcopy.info
