REP 4.2 Printer Jam Sensor
Parts List on PL 4.1
Removal
1. Remove power cord.
2. Remove document catch tray assembly
(REP 1.1).
3. Remove input tray / printer cover
assembly (REP 1.9).
4. Remove jam sensor bracket.
a.
Remove screw securing jam sensor
bracket.
b.
Remove jam sensor bracket.
5. Remove printer jam sensor. (Figure 1)
a.
Disconnect J406 at printer jam sensor.
b.
Release locking tabs, then remove
printer jam sensor.
Replacement
1. Reinstall sensor on jam sensor bracket.
2. Connect J406.
3. Ensure W6 wire harness is properly
routed through guide fingers. (Figure 1
of REP 4.1)
4. Reposition jam sensor bracket in locating
slot on upper printer frame and on
locating point, then secure with screw.
5. Reinstall remaining components in
reverse order.
REP 4.3 Printer Interlock Switch
Parts List on PL 4.1
Removal
1. Remove power cord.
2. Remove document catch tray assembly
(REP 1.1).
3. Remove coupler cover (REP 1.3).
4. Remove LH cover (REP 1.4).
5. Remove printer interlock switch.
a.
Disconnect J112 at A0 CNC PWB.
b.
Remove printer interlock switch
harness from twist tie.
c.
Remove screw securing printer
interlock switch.
d.
Remove printer interlock switch.
Replacement
1.
Reposition printer interlock switch on the
locating point and to rear of the tab on
the LH frame.
2.
Reinstall screw securing printer interlock
switch.
3.
Reinstall remaining components in
reverse order.
12/88
REP 4.2, 4.3
4-24
Telecopier 7017 / 7017SF
www.printcopy.info
www.printcopy.info
