Xerox DocuPrint C2428, User Manual, Page: 144 / 283

5.2 Description of Common Menu
144
5
Settin
g
Control
Panel
■
Adobe Protocol
Set the communication protocol for PostScript. This item is available when the PostScript Software
Kit (optional) is installed.
[Normal] (default)
Set when the communication protocol is ASCII format.
[Binary]
Set when the communication protocol is Binary format. According to data, the processing speed of
printing in Binary format may be faster than that of [Normal].
[TBCP]
Set when both ASCII format and Binary format is installed in one communication protocol, and to
switch by a specified control code.
●
Set proper form according to data output by the printer driver in the computer.
●
Use this menu in default, [Normal] for normal operation.
●
This settings can be used only when it is printed with PostScript.
Port 9100
Set when using Port9100.
■
Port Status
Set the status of the Port9100 port to enabled or disabled when the power is switched on. Default is
[Disable]. Set [Enable] when you use Port9100.
If memory becomes insufficient when the port is set to [Enable], the status of the port may be automatically set
to [Disable]. Set the status of the unused port to [Disable], or change the memory allocation capacity, in case of
insufficient memory.
To activate the port9100 port, you will need to set the IP address.
■
Print Mode
*1 (P.155)
Set the process method (targeted print language) of the print data.
[Auto] (default)
The proper process is automatically selected according to the language of the data received from the
computer.
[PS] [HP-GL/2] [PCL] [TIFF]
Each piece of data received from the computer is processed. [PS] is indicated when PostScript
Software Kit (optional) is installed.
■
PJL
*2 (P.155)
You can use the PJL command with this printer, which does not depend on any print language. The PJL
command controls the print job, and is necessary when you use the printer driver. Set the status of the PJL
command sent from the computer to enabled or disabled. By using the PJL command, you can select the print
language for the next data, even if the machine is under another process in any print language. Set [Enable] for
normal use. Default is [Enable].
■
Connect Time-Out
*3 (P.155)
Set the time to cut the connection from 2 to 65535 seconds, in 1 second increments while receiving
data. Default is [60Secs].
■
Port No.
Specify the port number on 9100 or select from 8000 to 9999. Default is [9100].