Xerox DocuPrint C2428, User Manual, Page: 139 / 283

5.2 Description of Common Menu
139
5
Settin
g
Control
Panel
LPD
Set when using LPD.
■
Port Status
Set the status of the LPD port to [Enable] or [Disable] when switching off the power. Default is
[Enable], which allows the use of the LPD port.
When the port is set to [Enable], and if there is insufficient memory, the status of the port may automatically be
reset to [Disable]. Set unused port status to [Disable] or change the memory allocation capacity, in case of
insufficient memory.
To activate the LPD port, you will need to set the IP address.
■
Print Mode
*1 (P.155)
Set the process method (targeted print language) for the print data.
[Auto] (default)
The proper process is automatically selected according to the language of the data received from the
computer.
[PS] [HP-GL/2] [PCL] [TIFF]
Each piece of data received from the computer is processed. [PS] is indicated only when the
PostScript Software Kit (optional) is installed.
■
PJL
*2 (P.155)
With this printer, you can use the [PJL] command, which does not depend on any print language. The
PJL command controls the print job, and is necessary when you use the printer driver. Setting the
status of the PJL command sent from the computer enables or disables it. By using the PJL
command, you can select the print language for the next data, even if the printer is under another
process in any print language. Set [Enable] for normal use. Default is [Enable].
■
Connect Time-out
*3 (P.155)
Set the time to cut the connection from 2 to 3600 seconds, in 1 second increments while receiving
data. Default is [16Secs].
■
TBCP Filter
Set the TBCP filter to enabled or disabled, while data from the PostScript is processed. This item is
available when the PostScript Software Kit is installed. Default is [Disable].
■
Port No.
Specify the port number as 515 or select from 8000 to 9999. Default is [515].