7-26
XEROX DFC165 & DWC165c Service Manual
7) Release the carriage from the rail on the front panel, then disconnect the cogged
belt from the carriage and the flat cable from its clips (see fig. 7-41).
Fig. 7-41
8) After replacing the carriage, perform the ALIGNMENT TEST (par. 6.1.1) and
PRINT CHART (par. 6.1.4).
7.2.16 Restoring the facsimile machine
During every disassembly or replacement procedure in which one or more connectors
have been unplugged from the motherboard, it is advisable to restore the facsimile
machine prior to complete the procedure.
1) Remove the motherboard, unplug the short-pin P (see fig. 7-42) and plug it again
after one second to be sure that the dynamic memory has been cleared
Fig. 7-42
carriage
cogged
belt
flat cable
P
