TOOLS MODE
3–38
DOCUMENT CENTRE CS 50 SYSTEM ADMINISTRATION GUIDE
1
2
3
4
5
6
7
Machine Timeouts
The Machine Timeouts feature allows you to
change the length of time the copier/printer waits
before returning to the default settings after a job
is complete or only partially programmed, entering
Power Saver mode, powering off, or exiting
System Administration mode. You may also
disable or enable a timeout option through the
Timeouts feature screens.
These screens do not have a Save button. When
you Close the screen, settings are automatically
saved. To change settings, access the appropriate
screen and change the settings.
The machine timeouts and settings are described
in Table 5.
Machine Timeout
Description
Setting
Job Completion
This sets the time for job completion
until the machine returns all selec-
tions to the default.
1- 59 seconds
1 - 10 minutes
Job Program
Incomplete
This sets the time for job program
incomplete until the machine returns
all selections to the default.
1- 59 seconds
1 - 10 minutes
Low Power
This sets the time for job completion
or last selection until the machine
enters low power mode.
1 - 240 minutes
Power Saver
This sets the time from the last selec-
tion until the machine enters power
saver mode.
1 - 240 minutes
Auditron Adminis-
tration / Tools Mode
Timeout
This sets the time from last selection
until the Auditron Administrator or
Tools Mode is exited.
10 - 60 minutes
Timeout Disabled
Network Controller
This sets the time for job timeout until
the machine discontinues access
through the Network Controller.
1 - 59 seconds
10 - 60 minutes
Timeout Disabled
(Recommended:
15 second)
Network Controller
Job Complete
This sets the time from job completion
until the machine discontinues access
through the Network Controller.
1 - 59 seconds
10 - 60 minutes
Timeout Disabled
(Recommended:
15 second)
Table 5: Machine Timeouts
Summary of Contents for Document Centre 50
Page 1: ......
Page 22: ...CONTENTS XXII DOCUMENT CENTRE CS 50 SYSTEM ADMINISTRATION GUIDE 1 2 3 4 5 6 7...
Page 137: ......