Xerox DocuColor 2045, Operator'S Manual

Page: 253 / 340

H
I G H
C
A P A C I T Y
S
T A CK E R
S
T A P L E R
( H C S S ) A
C C E S S O R I E S
D O C U C O L O R
2 0 6 0 / 2 0 4 5
O P E R A T O R M A N U A L
AC
CESSO
RIES
5–41
Using the High Capacity Stacker Stapler
Use the HCSS either by scanning documents and making your selections on the
Touch Screen, or by sending a document through the network and making your
selections under Job Properties/Parameters.
• Use the following instructions to select the High Capacity Stacker
Stapler when scanning prints on the digital press.
• If sending a job through the network, refer to the Printing Guide that
came with your Raster Image Processor for information on how to set
the job Properties/Parameters when using the HCSS.
Hints and Tips
The HCSS cannot staple jobs with mixed sizes of paper.
The stacking may be skewed on the output from mixed size paper jobs.
You can mix coated and uncoated stock.
The HCSS accepts jobs of mixed weight papers below 220 g/m
2
.
Only clear paper jams at the area indicated on the HCSS Control Panel. Do not
remove paper from any other areas of the paper path.
Stapling Hints
There are three stapling options:
• Single Staple Position 1
• Single Staple Position 2
• Dual Staple
If you select Single Staple, the screen in Figure 25 displays. Selecting Position 1
places a staple in the upper left corner of SEF or LEF sets. Position 2 places a
staple in the bottom left corner of SEF sets only.
Selecting Dual Staple places two staples closer to the top/bottom center of the
sheets than a single staple.