A
C C E S S O R I E S
H
I G H
C
A P A C I T Y
S
T A CK E R
S
T A P L E R
( H C S S )
D O C U C O L O R
2 0 6 0 / 2 0 4 5
O P E R A T O R M A N U A L
5–52
NOTE:
To undock the HCSS from the digital press, reach into the circular area
near the bottom of the HCSS for the Undocking Lever. Refer to the picture below.
Figure 31. HCSS Undocking Lever
Pull the lever toward you and hold it in position while moving the HCSS a small
distance (25.4mm, 1") away from the press. Release the lever and continue to
move the HCSS as far as required.
Fault Code 052-321
Connection problem
•
Cancel or save the job.
•
Power off the digital press. Wait 15 seconds and power on.
Fault Code 052-320
Unexpected connection
•
Cancel or save the job.
•
Power off the digital press. Wait 15 seconds and power on.
Fault Code 052-312
Communication problem
•
Cancel or save the job.
•
Power off the digital press. Wait 15 seconds and power on.
Ready Indicator does not
illuminate
No power
•
Check the power cord connected to the power source.
•
Check that the main switch is on.
Poor Stacking:
Mixed sizes of paper
Run separate jobs and empty stacker.
High paper curl
•
Adjust digital press decurler.
•
Flip paper in digital press paper tray(s).
•
Rotate paper in the digital press paper tray(s).
Mechanical obstruction
•
Check for obstruction in the stacker stapler paper path.
•
Ensure that all transports and baffles are properly seated.
Paper Jams:
Use Top Tray
Deselect offset or restart job to the Top Tray.
High paper curl
•
Adjust digital press decurler.
•
Flip paper in digital press paper tray(s).
•
Rotate paper in the digital press paper tray(s).
•
Switch to heavier paper.
Problem
Cause
Solution
Undocking Lever
inside here
Summary of Contents for DocuColor 2045
