Initialisation of an IVC unit after replacement
International L – edition: 17.02.2006
67
20
Initialisation of an IVC unit after replacement
The factory normally supplies IVC controls with the correct code installed for each machine type.
If the unit shows no response after a replacement has taken place, we recommend that you control
and/or re-program some machine codes. Apply key D and + in service program 15 (You can also try
entering the four digits while keeping button P pressed. This does not, however, apply in all cases).
NOTE: Initialisation of an I.V.C. unit using a P.C. with I.V.C. programmer software (
) makes manual programming unnecessary. To achieve this you need the data file of the
machine which has to be programmed. The file can be copied from an identical machine and stored
on harddisk for use on future initialisations. It is recommended to store data for each machine, so
that if an IVC has to be exchanged, then prices do not have to be reprogrammed.
20.1
Preparation for initialisation
Press key P - hold it - and press key S three times, display
shows
When you press selection button 1, the display should show the
configuration numbers in four digits after the equals sign, e.g.
3480 (code number for machines with Executive system).
If no configuration numbers are displayed when you press but-
ton 1, 2, 5 or 9 in service program 15 it is possible that no place holders have been programmed. In
this case you should re-programme message 13 as described in
possibility is to delete complete text memory
) and then start to re-pro-
gram.
NOTE: In this case all messages including place holders have to be re-programmed.
20.2
Programming of configuration numbers
In this example the control unit should be programmed to 7620 (MDB sysrem) in service program 15,
button 1:
Press key P - hold it - and press key S three times, display
shows service program 15 "Main Configuration"
Press selection button 1, display is
or with an empty text memory shows
Press button D, number 0 outside is blinking
With you can change the blinking 0 to a number be-
tween 1 and 9. In this case (7620) the character stays 0.
15 MAIN
CONFIGURATION
SELECTION:
01 =3480
15 MAIN
CONFIGURATION
SELECTION:
01 =3480
34.80
SELECTION:
01 =0000
