Setup & Operation
Starting The Motor
Setup & Operation
HDSdoc030722
2-24
2
At least once a year the electric wires should be checked for isolation and hazardous voltage by
a qualified person.
Keep the electrical starter box clean. Remove any dust or wood chips from the box from time to time.
Make sure the electric box door is closed before operating the sawmill.
WARNING!
Hazardous voltage inside the electric box and inside the
motor can cause shock, burns, and death. Turn the main switch to the
OFF (“0”) position and lock out power supply before opening the box
door!
The time-delay relay in the electrical starter box attached to the hydraulic box should be set between
4 and 5 seconds.
After installation, test the sawmill for proper motor rotation.
If rotation is incorrect, turn the motor off pushing the STOP button located on the control box. Turn
the main switch on the starter box to the OFF (“0”) position. Disconnect the power cord on the left
side of the starter box.
Use the screwdriver to turn the phase converter switch to the left or to the right to change the motor
rotation.
CAUTION!
If at any time you need to immediately stop the blade
motor, press the emergency stop button located on the control box.
