Safety & General Information
Sawmill Maintenance
1
1-7
HDSdoc030722
Safety & General Information
CAUTION!
Do not over-tighten the contact set screws on the hydraulic
valve assembly.
Over-tightening may cause the threads in the screw
hole to strip
.
CAUTION!
Due to variations in the vertical mast, the pad spacing may
vary throughout the travel of the saw head. Check the pad spacing at
the top and bottom ends of the mast only. Pads adjusted too tight will
cause premature up/down motor failure.
CAUTION!
It is important that the lower stop bolts are properly
adjusted to secure the carriage on the track rail. Failure to properly
adjust the stop bolts can cause saw head damage, especially during
mill transportation.
CAUTION!
Pressure should not exceed 2000 psi. If it does, the amp
draw will rise above the design maximum of 200 amps, and could
cause battery and system problems. Pressure above 2000 p.s.i. may
also damage the hydraulic hoses.
CAUTION!
Failure to remove sawdust buildup from the battery box lid
and/or track rail cover could result in damage to these parts when the
saw head is lowered to its lowest position.
See Table 1-1.
Pictogram decals used to warn and inform the user about danger in the LT40.
TABLE 1-1
Decal View
W-M No.
Description
096317
CAUTION! Read thoroughly the manual
before operating the machine. Observe all
safety instructions and rules when
operating the sawmill.
099220
CAUTION! Close all guards and covers
before starting the machine.
099220
