12
Force 30 Owners Manual
2015
Slide the inlet pipe over the auger tube. The hole in
the inlet pipe should be 180 degrees towards the out
-
let on the T-pipe.
Slide the blue tube to the outlet of the T-pipe, and
the cap on the end of the inlet pipe. The auger is now
ready to be installed.
Installation
Route the auger spiral through the T-pipe and slide the
auger motor over the other end of the T-pipe.
Fasten the motor to the T-pipe. Make sure that the
T-pipe and the wire connection on the motor point in
the same direction.
Slide the inlet pipe over the auger tube. The hole in
the inlet pipe should be 180 degrees towards the out
-
let on the T-pipe. Fasten the screw shown to lock the
inlet pipe in place.