TECHNICAL
SPECIFICATIONS
The high efficiency downflow gas furnace may be installed
free standing in a utility room, or enclosed in an alcove or
closet. The extended flush jacket provides a pleasing
“appliance appearance.” Design certified by the Canadian
Standards Association (CSA). The product is truly designed
with the contractor and the consumer in mind.
FEATURES & BENEFITS
• Best warranty in the business -
– A lifetime warranty on the heat exchanger
– 8 Year Limited Parts and 5 Year Quality Pledge
• 100% fired and tested -
All units and each component
(both mechanical and electrical) are tested on the
manufacturing line.
• Best packaging in the industry -
Unique design assures
product will arrive to the homeowner dent free.
• Clean and quiet operation -
Due to the unique design of
in-shot burners, location of inducer, return air vents, and
use of insulation.
•
Fixed 30 second blower delay
at burner start-up assures
a warm duct temperature at furnace start-up. Adjustable
blower off settings (60, 120, 160 and 180 seconds).
•
Fixed 30 second post purge
increases life of heat
exchanger.
• SmartLite
TM
Control Board —
Provides extended life to
ignitors in furnaces using hot surface ignition technology.
Programmed to learn the heat-up characteristics of the
ignitor, then adapt the ignition time to the characteristics
of the furnace so the ignitor is energized appropriately.
•
Dependable, hot surface ignitor -
Innovative application
of an appliance type ignitor with a 20 year history of
reliability, assures no callbacks because of handling.
•
Color coded wire harness -
Designed to fit the
components, all with quick-connect fittings for ease of
service and replacement.
•
Tubular primary heat exchanger -
Heavy gauge
aluminized steel heat exchanger assures a long life.
•
Stainless steel secondary heat exchanger
assures long
life.
•
90-second fixed cooling cycle blower-off delay (TDR)
increases cooling performance when matched with a
NORDYNE coil.
•
Approved for direct vent furnace, category IV venting
system –
May be vertically or horizontally vented using
either a one-pipe or two-pipe system for maximum flexibility
in installation.
•
Fully insulated blower cabinet
for quiet operation.
•
Multi-speed direct drive blower -
Designed to give a
wide range of cooling capacities. 40VA transformer included.
•
LP convertible -
Simple burner orifice and regulator spring
change for ease of convertibility.
•
Diagnostic light flashes identify limit failure, pressure
switch failure and improper ground and polarization -
for easy troubleshooting.
•
Incorporates integrated control board
with connections
for electronic air cleaner, humidifier and twinning.
•
Factory installed drain system
for reliable performance.
•
Door design
enhances furnace appearance and uses
screw fasteners for great fit and accessibility.
•
3 amp fuse
protection against high and low voltage shorts;
protects transformer and control board.
•
Low voltage terminal board
for easy field wiring.
•
Components and Controls -
Designing quality into our
products means selecting manufacturers that have a
reputation for delivering high quality, dependable products.
FG6RL Series
High Efficiency / Direct Vent or Non Direct Vent
Condensing Downflow Gas Furnace
Induced Draft - 92.1 AFUE
Input 40,000 - 120,000 Btuh
