18
SDC-10
1080p D-IL A
®
3D Front Projector
User’s Manual
Main Input Terminal
HDMI 1 Terminal
You can connect any source component equipped with an HDMI output. There is also a M3 locking hole (hole depth 3mm).
HDMI 2 Terminal
You can connect any source component equipped with an HDMI output. There is also a M3 locking hole (hole depth 3mm).
LAN Terminal (RJ-45)
This is a LAN-terminal. The projector may be operated via networked PC or system controller commands.
RS-232C Terminal (male D-Sub 9 pin)
This is a standard RS-232C interface terminal for external system controller connectivity.
COMPONENT Terminals (RCA x 3)
Standard input terminals for analog RGB (Synch on G), component (Y, Cb, Cr), DTV format (Y, Pb, Pr) video signals.
3D SYNCHRO Terminal
3D synchro emitter connector: connect the external 3D emitter (sold separately) to enjoy 3D content.
PC Terminal (D-Sub 15 pin)
Input terminal used to connect any Personal Computer (RGB video and sync signals).
Trigger (
)
12V DC power supply output terminal (100mA). This is typically used to control motorized or masking screens; contact your
Wolf Cinema installer for further details.
IR REMOTE terminal (Stereo mini jack)
This terminal may be used with compatible third party IR sensors, in the event the main chassis IR sensor(s) are hidden or otherwise
inaccessible. Consult with your authorized Wolf Cinema dealer or installer for further details and technical support.
1
HDMI
2
RS-232-C
C
R
/P
R
C
B
/P
B
Y
3D
SYNCHRO
PC
TRIGGER REMOTE
CONTROL
LAN
HDMI 1
3D Synchro
PC
IR Trigger
RS-232C
Component
Remote
HDMI 2
LAN
Note:
Damage can be caused to third party equipment if the connection is performed incorrectly. (Tip = DC +12 V, Sleeve = GND)
Summary of Contents for SDC-10
Page 1: ...SDC 10 ...