WirelessAlert VA-2, User Manual

Page: 12 / 61

•
VoiceAlert 2 User Manual
Built-in microphone (Mic): For recording zone voice messages and for allowing user to “listen-in” to VA 2 via
telephone or cell phone during alarm event.
LCD Screen: Displays all configuration settings and system status. (e.g. the screen above displays
configuration address code 51 (wireless zone 01), as part of adding sensors onto the VA
2
).
Configuration of VA
2
Each VA 2 configuration setting has a unique address code. Refer to the table below to quickly navigate to the
address code for the setting you wish configure. Please fill in the Configuration Record Table in the SID
(Appendix 4) as a record of all configurations performed on your VA
2 .
Note: Prerequisite configurations are highlighted. You must set these for basic operation of VA 2 .
TABLE1: Configuration Address Codes - Quick Reference
Address Code Setting Default Value Page
01 Code 01 - Adding Recipient Telephone Number 1 Empty 13
02 Code 02 - Adding Recipient Telephone Number 2 Empty 15
03 Code 03 - Adding Recipient Telephone Number 3 Empty 16
04 Code 04 - Adding Recipient Telephone Number 4 Empty 16
05 Code 05 - Adding Recipient Telephone Number 5 Empty 16
06 Code 06 – Set Password for Arming / Disarming 1234 17
07 Code 07 – Set the Number of Ringing Times Before VA2
Answers Incoming Telephone Call 5 17
08 Code 08 – Set Zone Alarming Delay (Entry Delay) and
Zone Arming Delay (Exit Delay) 0000 18
09 Code 09 – Set Siren Sounding Time for Alarm and Panic
Events Empty 19
10 Code 10 – Set 433MHz RF Signal Reception and Arming /
Disarming Status for Wireless Zones 23 19
11 Code 11 – Set Recipient Voice Call Notification 00 21
12 Code 12 – Set Daily Alarm Clock Empty 22
13 Code 13 – Set Grouped Zone Arming / Disarming:
Automatic (timed) Group 1 Empty 24
14 Code 14 – Set Grouped Zone Arming / Disarming:
Automatic (timed) Group 2 Empty 24
15 Code 15 – Set Grouped Zone Arming / Disarming: Manual
(via remote, console keypad or telephone keypad) 12345678 24
16 Code 16 – Set Allocated Zone List for Sounding Siren 0 26
17 Code 17 – Set Siren, Wired Zone, Telephone Line
Tamper, and Arming / Alarming Delay Buzzer Not set 27
18 Code 18 – Set Panel Date and Time Not set 27
19-22 Codes 19 to 22 – Check Alarm Log for the 1st – 4th Most
Recent Alarm Event Not set 28
23 Code 23 – Check Most Recent Power On Event Not set 29
24 Code 24 – Set Zone Voice Message Playback Over
Recipient Telephone and or Voice Message Playback
Over Built-in Speaker Not set 30
25 Code 25 - Set zone chime function (Detailed in advanced
manual). Not set
26 Code 26 - Set contact ID settings for alarm company
monitoring via contact ID protocol (Detailed in advanced
manual). Not set
27 Code 27 - Set contact ID codes for each zone (Fire, panic, Empty
Copyright InFocus Trading 111 cc, 2009 12