•
VoiceAlert
2
User Manual
Important:
Be careful when coding sensors onto the wireless zones, not to trigger random sensors
accidentally while in coding mode. This will prevent confusion as to which sensor has coded onto which
zone. Always place sensors out of the way and make sure that they cannot be triggered until you are ready
to trigger them for coding onto their correct zone. Also be aware of any existing sensors in the area that may
be triggered by other persons walking past them while you are trying to code new sensors.
Hint:
You can recode a particular zone to link with a different sensor by recalling the particular zone key,
using configuration key 51, and then activating the sensor as per procedure below. This will overwrite the
existing RF code with the new sensor’s code.
Hint:
For sensors with fixed 8 bit code, take note of the code when it appears in the LCD screen and then
use this code to set DIP switch on sensors that can have their code set manually. This will allow for use of
more than one different type of sensor for the same zone.
Function Options:
1. For coding of wireless sensors VA
2
’s wireless zones.
2. For overwriting existing coded zone with RF signal from new sensor.
3. For deleting all wireless coded signals from the wireless zones.
Procedure Function Option 1:
•
Press
Return
(Inverted Arrow)
•
Press
PRG
•
Enter
51
•
Press
OK
•
Enter
01
•
Press
OK
•
Trigger the sensor you wish to code onto wireless zone 01.
•
You will hear a beep sound and the sensors unique 8 bit code will then appear on the LCD. Make
sure to record this code for future reference. Do the same for all additional coded sensors. (Please record
all RF codes and their corresponding zone key numbers in SID document: See Appendix 4)
•
Press
OK
•
Note the key has rolled over to the next number (02), for coding of sensor RF signal onto the next
wireless zone.
•
Trigger the next wireless sensor you wish to code.
•
Press
OK
•
Proceed as above for all zones you wish to code.
•
Press
Return
to exit
Procedure Function Option 2 (e.g. change RF code associated with wireless zone 4):
•
Press
Return
(Inverted Arrow)
•
Press
PRG
•
Enter
51
•
Press
OK
•
Enter
04
•
Press
OK
•
Trigger the sensor you wish to code onto wireless zone 04.
•
You will hear a beep sound and the sensors unique 8 bit code will then appear on the LCD. Make
sure to record this code for future reference. Do the same for all additional coded sensors. (Please record
all RF codes and their corresponding zone key numbers in SID document: See Appendix 4)
•
Press
OK
•
Press
Return
to exit
Copyright InFocus Trading 111 cc, 2009
39
