PROCEDURE
1
If there is a clutch coupling between engine and propeller, do the steps that follow:
1.1
Engage the clutch coupling.
1.2
Keep the clutch coupling engaged during operation to prevent damage to the
engine.
2
Select the applicable control panel.
3
Start the auxiliary blowers.
4
Set the minimum fuel injection quantity.
4.1
For UNIC, do as follows:
4.1.1
Use the rotary button on the LDU-20 to select the fuel command button.
4.1.2
Turn the rotary button to set the fuel injection quantity to approximately
30%.
4.2
For WECS, do as follows:
4.2.1
Push the button FUEL CONTROL MODE.
4.2.2
Turn the rotary button to set the fuel injection quantity to approximately
15%.
5
Push the button START AHD or START AST to start the engine.
NOTE:
The ECS starts an automatic pre-lubrication sequence with a specified number
of pulses.
NOTE:
The ECS increases the engine speed.
6
If new cylinder liners or piston rings were installed, do a running-in, refer to
.
7
Slowly turn the rotary button to adjust the fuel injection quantity.
NOTE:
The ECS changes the engine speed.
CLOSE UP
•
None
X52
AA00-0000-00AAA-131A-A
Operation Manual
Start the engine
Winterthur Gas & Diesel Ltd.
- 289 -
Issue 002 2018-11
