Kunststoffschweißtechnik
Operating
and
indicating elements
Chapter 4
25.03.14
Working Instructions WIDOS ASM 315 WM
Page 20 of 45
4.5. Clamping tool left, for main pipe
You may adjust the clamping of the claws by slightly turning in and out the adjusting screws.
The main pipes must always be clamped tightly using the levers.
Clamp pipes with OD 315 mm into the clamping tool.
Screw reducer inserts into the clamping tool for pipes with OD 90 – OD 280 mm.
The reducer inserts have a dimension marking.
They may be screwed to the clamping claws from the in and outside.
You may shift the clamping tool on the machine table if necessary.
For this purpose detach the two pan-head screws and shift the clamping tool to the requested
position. Please observe that the outer slot nut is still well-guided in the table.
Rear clamping claws
shut, lever
clamped
Front clamping claws
shut, lever
not
clamped
Open clamping
claw
Reducer insert
Hexagon-head screw
Fixing screw for
reduction inserts
Adjusting screw
