Kunststoffschweißtechnik
WIDOS
Einsteinstr. 5
Phone +49 (0) 71 52 99 39 - 0
W. Dommer Söhne GmbH D-71254 Ditzingen-Heimerdingen
Fax
+49 (0) 71 52 99 39 - 40
Website:
www.widos.de
Email:
25.03.2014
Working Instructions WIDOS ASM 315 WM
Page 21 of 45
5. Starting and operating
The instructions of this chapter are given as an introduction into the operation of the machine
and as guidelines for the appropriate starting of the machine. This includes:
the safe operation of the machine
using all the possible options of the machine
economic operation of the machine
5.1. Starting
Unpack machine, remove packing material.
The machine has been screwed to the wooden floor for
the transport, detach screws.
Grab machine and take it to its destination.
Put up the heating element on the bolt of the right side.
Plug the heating element into the power socket of the
control unit and connect the control unit to the power
supply 230 V / 16 A / 50 Hz.
Mount the loosely included handles into the left clamping
tools.
Connect the drill with power supply 230 V / 16 A / 50 Hz.
Now machine is ready for use.
The machine may only be operated by trained and authorized people.
For the qualification, a plastic welding exam can be taken according to DVS and
DVGW.
In situations of danger for persons and the machine, the mains plug has to be unplugged
immediately.
After completion of the welding work and during breaks the machine has to be switched off.
Further take care that no unauthorized person has access.
Protect the machine from wetness and humidity !
According to VDE 0100, the use on construction sites is only allowed with a power
distributor with a FI-security protective switch.
Lay electric wires carefully (danger of stumbling!)
Take into account the surrounding conditions:
-
The welding may not be performed under direct sun rays influence.
If the surrounding temperature is under 5°C, measures have to be taken:
-
Preheat the pipe ends if necessary.
In addition, take measures against rain, wind and dust.
