WhitakerAudio JC Whitaker 20 W Stereo Integrated Audio Amplifier, Manual

Page: 90 / 196

90
WhitakerAudio
• Circuit breaker CB51
• RCA input jacks (J101, J102, J103, J104)
• AC power connector
• Ground lug hardware
• Back panel decal
– Mount the four RCA input jacks using the #4 hardware provided. Orient the components
so the ground lug faces downward toward the chassis bottom plate.
– Mount the ground lug terminal. Place the three ground lugs on to the 3/4-inch long #6
screw provided. Using a pair of long-nose pliers, bend the ends of the three lug upward
(toward the head of the screw). Insert the screw into the back panel hole so the screw
protrudes out of the back chassis. Install a lockwasher on the screw, and then the lock-
tight nut. Spread the ground lugs on the inside of the chassis so they can be used
individually. Tighten the lock-tight nut. Install two flat washers on the screw and then the
wing nut. Tighten the wing nut finger-tight. The finished installation is shown in Figure
5.8.
– Install circuit breaker CB51 using the hardware provided. Position the device so the
number rating is properly oriented when viewed from the rear. Run the decorative nut
Figure 5.7 Completed front panel.