WhitakerAudio JC Whitaker 20 W Stereo Integrated Audio Amplifier, Manual

Page: 121 / 196

121
20 W Stereo Integrated Audio Amplifier
• The sleeve is the common (ground) connection.
• The ring is the right channel connection.
• The tip is the left channel connection.
– Prepare a 19-inch long 2-conductor shielded cable. Remove 4-inches of insulation from
one end, and 2-inches of insulation from the other end. Attach a quick-disconnect terminal
to each of the wires (black, white, and shield drain) on the 4-inch side. Attach the
connectors as follows:
• White to the HEAD1 terminal on the right channel speaker PWB.
• Black to the HEAD1 terminal on the left channel speaker PWB.
• Shield to the GND terminal on the left channel speaker PWB.
– Route the 2-conductor shielded cable to the front panel and the1/4-inch headphone jack
(J1). Make the following connections:
• White to the ring terminal on J1. Solder.
• Black to the tip terminal on J1. Solder.
• Shield to the sleeve terminal on J1. Solder.
– Prepare a 19-inch long 2-conductor shielded cable. Remove 4-inches of insulation from
one end, and 2-inches of insulation from the other end. Attach a quick-disconnect terminal
to each of the wires (black, white, and shield drain) on the 4-inch side. Attach the
connectors as follows:
• White to the HEAD2 terminal on the right channel speaker PWB.
• Black to the HEAD2 terminal on the left channel speaker PWB.
• Shield to the GND terminal on the right channel speaker PWB.
– Route the 2-conductor shielded cable to the front panel and the3.5 mm headphone jack
(J2). Make the following connections:
• White to the ring terminal on J2. Solder.
• Black to the tip terminal on J2. Solder.
• Shield to the sleeve terminal on J2. Solder.