WhitakerAudio JC Whitaker 20 W Stereo Integrated Audio Amplifier, Manual

Page: 137 / 196

137
20 W Stereo Integrated Audio Amplifier
position #1 and white to position #2. Process (heat) the end of the cable at the 4 pin Molex
connector.
– Insert the free end of the 21-inch long audio cable wires into the 12 terminal Molex header
as follows:
• White to pin #9 (left output)
• Shield to pin #10 (GND)
– Using a heat gun, process the heat shrink tubing on the end of the cable.
– Prepare a 10-inch long #22 black wire. Attach a connector pin to one end of the wire.
Insert into the 12 terminal Molex header as follows: black to pin #12 (GND).
– Insert the 12 terminal Molex connector just assembled into CONN105 on the preamplifier
PWB. Note that pin 1 faces the rear of the chassis.
– Find the cable from terminals 1–4 of CONN105 on the preamplifier board. Route the
cable to the front panel Bass Control . Connect the wires to R127b as follows:
• Red to terminal #1 (low). Solder.
• White to terminal #2 (arm). Solder.
• Black to terminal #3 (high). Solder.
• Clip off the shield drain wire. It is not used on this end.
– Find the cable from terminals 5–8 of CONN105 on the preamplifier board. Route the
cable to the front panel Treble Control . Connect the wires to R132b as follows:
• Red to terminal #1 (low). Solder.
• White to terminal #2 (arm). Solder.
• Black to terminal #3 (high). Solder.
• Clip off the shield drain wire. It is not used on this end.
– Find the audio cable from terminals 9–10 of CONN105 on the preamplifier board. Insert
the 4-pin Molex connector into the Conn2 position on the left channel PWB. Make certain
to properly orient the connector on the board.
– Find the #22 black wire from terminal 12 of CONN105. Connect to the #6 position (right)
on SW101. Solder (2 wires).