WhitakerAudio JC Whitaker 20 W Stereo Integrated Audio Amplifier, Manual

Page: 70 / 196

70
WhitakerAudio
– Slide the heat-shrink tubing into position at the base of the socket. Apply a stream of hot
air to shrink the tubing over the pins. Be careful to not apply too much heat.
– Replace the standoff removed from the V4 socket. The screws should be finger-tight.
Remember to include the lockwasher on the component side of the board. The heater leads
should straddle the standoff.
– Twist the wires together and route to socket V5 (see Figure 5.2 d for placement). The wires
should be placed at socket-level. In this way they will be resting against the chassis when
the board is inserted in the chassis. Do not dress the wires against the PWB as this may
increase hum in the output of the amplifier.
– Trim the wire lengths as needed to comfortably reach V5. As before, slip a piece of heat-
shrink tubing over each wire. Crimp the brown wire on pin 5, and then crimp the green on
pin 4. Do not solder.
– Cut one 9-inch piece of #22 green wire and one 9-inch piece of #22 brown wire. Slip the
brown wire through the heat-shrink tubing on the lead already connected to pin 5 of V5.
Route the wire to the pin and crimp in place. Solder, keeping the heat-shrink tubing away
from the hot wires and the soldering iron. Slip the green wire through the heat-shrink
tubing on the lead already connected to pin 4 of V5. Route the wire to the pin and crimp in
place. Solder, keeping the heat-shrink tubing away from the hot wires and the soldering
iron.
– Slide the heat-shrink tubing into position at the base of the socket. Apply a stream of hot
air to shrink the tubing over the pins. Be careful to not use too much heat.
– Replace the standoff removed from the V5 socket. The screws should be finger-tight.
Remember to include the lockwasher on the component side of the board. The heater leads
should straddle the standoff.
– Twist the wires together and route to socket V6 (see Figure 5.2 d for placement). The wires
should be placed at socket-level. Do not dress the wires against the PWB.
– Trim the wire lengths as needed to comfortably reach V6. As before, slip a piece of heat-
shrink tubing over each wire. Crimp the brown wire on pin 5, and then crimp the green on
pin 4. Do not solder.