WhitakerAudio JC Whitaker 20 W Stereo Integrated Audio Amplifier, Manual

Page: 119 / 196

119
20 W Stereo Integrated Audio Amplifier
disconnect terminal (two wires crimped together). Connect to the free coil post on the
right channel speaker relay, RYL1.
– Route the free ends of the 10-inch long yellow wires to RYL2 on the left channel speaker
terminal PWB. Twist the wires together. Insert the two connectors into the left channel
RYL2 coil posts.
– Prepare a 12-inch long #18 black wire. Connect one end to the available ground lug on the
back panel that also includes the ground wire from the preamplifier PWB. Do not solder.
– Attach a quick-disconnect terminal to the free end of the 12-inch #18 black wire. Attach to
one of the GND posts on the right channel speaker PWB.
– Prepare an 8-inch long #18 black wire. Connect one end to the ground lug on the back
panel that also includes the ground wires from the preamplifier and right channel speaker
PWBs. Solder (3 wires).
– Attach a quick-disconnect terminal to the free end of the 8-inch #18 black wire. Attach to
one of the GND post on the left channel speaker PWB.
– Find the 4-inch long #18 black wire from the right channel speaker terminal. Attach to the
SPK GND post on the right channel speaker terminal PWB.
– Find the 4-inch long #18 black wire from the left channel speaker terminal. Attach to the
SPK GND post on the left channel speaker terminal PWB.
– Find the 4-inch long #18 yellow wire from the right channel speaker terminal. Identify the
Normally Closed (NC) post on right channel speaker relay RYL1. Attach the yellow wire
to the NC post.
– Prepare a 4-inch long #18 yellow wire. Attach a quick-disconnect terminal to each end.
Secure one end of the wire to the LOAD terminal on the right channel speaker terminal
PWB.
– Identify the Normally Open (NO) contact on right channel speaker relay RYL1. Connect
the 4-inch yellow wire from right channel Load terminal to the NO post on RYL1.