78
WhitakerAudio
underneath the chassis. Be careful to not scratch the top-side finish when tightening the
nut. Once the device has been mounted, place the potentiometer in the approximate center
position using a common-blade screwdriver. The smaller-diameter nut provided with the
control is used to secure the position of the device to prevent accidental movement. Place
the locking nut on the shaft (finger-tight).
– Mount R99 –
10 k
Ω
potentiometer
– FM Right Channel Gain Control. Note the tab
extending from the component toward the front of the device. Using a pair of long-nose
pliers, bend the tab down to the base of the potentiometer. Place the lockwasher provided
on the shaft and insert the device through the mounting hole. Secure with the flat washer
and large nut provided. Before tightening the nut, orient the terminals so they are easily
accessible from underneath the chassis. Be careful to not scratch the top-side finish when
tightening the nut. Once the device has been mounted, place the potentiometer in the
approximate center position using a common-blade screwdriver. The smaller-diameter nut
provided with the control is used to secure the position of the device to prevent accidental
movement. Place the locking nut on the shaft (finger-tight).
– Mount R102 –
10 k
Ω
potentiometer
– FM Left Channel Gain Control. Note the tab
extending from the component toward the front of the device. Using a pair of long-nose
pliers, bend the tab down to the base of the potentiometer. Place the lockwasher provided
on the shaft and insert the device through the mounting hole. Secure with the flat washer
and large nut provided. Before tightening the nut, orient the terminals so they are easily
accessible from underneath the chassis. Be careful to not scratch the top-side finish when
tightening the nut. Once the device has been mounted, place the potentiometer in the
approximate center position using a common-blade screwdriver. The smaller-diameter nut
provided with the control is used to secure the position of the device to prevent accidental
movement. Place the locking nut on the shaft (finger-tight).
– Install the mounting hardware for V6, the tuning indicator, using the #4 hardware
provided. Once installed, temporarily place the tube in position and check that it aligns
properly with the front panel opening.
– Carefully peal off the backing for the top chassis decal. Position it on top of the chassis, to
the right of the AM tuning control. Be sure to avoid the chassis screws. Apply the decal.
Summary of Contents for AM/FM Stereo Tuner 2012
