97
AM/FM Stereo Tuner
– Insert the Molex socket into the
Conn6
(Stereo Out) connector on the FM tuner PWB.
Note that the drain wires go to the last positions.
– Route the cables to the front panel output switch using the available cable clamp alongside
the FM tuner PWB. Leave the ends free for now. They will be connected later.
– Prepare a 22-inch long audio cable. Attach connector pins to each of the two wires on one
end of the audio cable. Insert the connector pins into the socket housing as follows: shield
to position #1 and white to position #2.
– Cut two short pieces of heat-shrink tubing, each about 3/4-inch long. Place the tubing at
each end of the audio cable. Process.
– Insert the Molex socket into the
Conn2
(Audio Out) connector on the FM tuner PWB.
Note that the drain wire goes to the first position.
– Route the cable to the front panel output switch using the available cable clamp alongside
the FM tuner PWB. Leave the end free for now. It will be connected later.
– Prepare a 31-inch audio cable. Cut two short pieces of heat-shrink tubing, each about 3/4-
inch long. Place the tubing on the ends of the cable. Process.
– Connect one end of the cable to the Right Channel RCA output jack on the back panel.
Solder the white conductor to the center pin. Connect the shield wire to the ground (shell)
end. Do not solder.
– Cut a 2-inch #22 black wire. Connect one end to the ground (shell) terminal on the Right
Channel RCA output jack. Solder (2 wires). Connect the other end to the available lug on
the back panel central ground point. Do not solder.
– Dress the audio cable to rest against the chassis, and route to the front panel output switch
using the cable clamps provided alongside the FM tuner PWB. Leave the cable free for
now. It will be connected later.
– Prepare a 31-inch audio cable. Cut two short pieces of heat-shrink tubing, each about 3/4-
inch long. Place the tubing on the ends of the cable. Process.
Summary of Contents for AM/FM Stereo Tuner 2012
