41
AM/FM Stereo Tuner
– Install R5, R15 –
33 k
Ω
, 2 W
. Solder in place, providing about 1/4-inch clearance above
the board.
– Install R6 –
22 k
Ω
, 0.5 W
.
– Install R7 – 15
k
Ω
, 2 W
. Solder in place., providing about 1/4-inch clearance above the
board.
– Install R9, R16, R22, R26 –
2.2 k
Ω
, 0.5 W
. Solder in place.
– Install R10 –
3.3 m
Ω
, 0.5 W
. Solder in place.
– Install R11, R12 –
2.2 m
Ω
, 0.5 W
. Solder in place.
– Find R13 –
27 k
Ω
, 0.5 W
. Set this component aside. It may be used later.
– Install R17 –
33 k
Ω
, 0.5 W
. Solder in place.
Figure 5.1
Recommended procedure for mounting the quick-disconnect tabs on the PWB: (
a
)
insert the tap using pliers and carefully work it into the board, (
b
) position the tab so it is
perpendicular to the board, (
c
) check to make certain that the mounting pins extend outside the
foil side of the board, (
d
) solder in place.
(
a
)
(
b
)
(
c
)
(
d
)
Summary of Contents for AM/FM Stereo Tuner 2012
