Wexxar WF-10T, Operation And Service Manual

Page: 81 / 156

WF-10T Case Former Case Size Adjustments
7-69
7.14
Quick Size Change Guide
The case size change table (Table 22) in this section is used to make case size changeover
simpler and faster. For each case, the optimum set-up parameters can be determined and
entered into Table 22. Once established, the table is a guide for operators, greatly reducing the
time required to adjust and fine-tune the machine set-up.
Most table entries are self-explanatory. Other settings, such as ‘Pinblock Mounting Orientation’,
are not so straightforward. The following pages include a suggested method for tabulating these
parameters.
Table 22: Dimension Adjustment Reference
CASE IDENTIFICATION OR
PRODUCT COUNT
ADJUSTMENTS SECTION
Refer to Section 7:
‘Case Size Adjustments’
in the Operation and Service Manual.
Case Blank Length ‘A’ 7.6
Bottom Flap Height ‘M’ 7.7
Case Blank Height ‘B’ 7.8
Jawplate Formed Case
Width ‘D1’
7.9
Horizontal Pinblock
Adjustments
7.9.1
Pinblock Mounting
Orientation
7.9.2
Center Ski Formed
Case Width ‘D2’
7.10
Conveyor Formed
Case Width ‘D3’
7.11
Carriage Formed Case
Length ‘C’
7.12
NOTE: Make a copy of Table 22 and keep the original
for future use.
NOTE:
This quick-change guide should not be used as a
substitute for proper operator training. All personnel
making adjustments to this machine should be familiar with
Section 7: ‘Case Size Adjustments’ and Section 8.5:
‘Maintenance Adjustments’ of this manual.