Wexxar WF-10T, Operation And Service Manual

Page: 57 / 156

WF-10T Case Former Operating Procedures
6-45
6.3.3 Magazine Pushers
Two magazine pushers hold the stacked cases
vertically and provide a moderate gravitational
directional force to help move the cases towards
the separator end of the magazine.
1) Place some case blanks in the magazine.
2) Pull one of the magazine pushers out by
the handle, pivoting it and sliding it up the
magazine guide rail until it is behind the
last stacked case. Repeat the procedure
for the magazine pusher on the opposing
side.
3) If desired, or if you wish to load multiple
case blank stacks at once, you may lift the
magazine pushers one-at-a-time and lock
them in position in the magazine pusher
locks at the infeed end of the magazine.
4) Unformed cases have a tendency to pack
tighter at the bottom that at the top,
resulting in a gap between the tops of the
cases. Splayed cases in the magazine can
lead to case jams or missed picks, so it is
important to adjust the wingnuts on the
adjustable magazine pushers so that the
cases line up vertically.
Figure 6-2: Magazine Pusher
Figure 6-3: Magazine Pusher
in Locked Position
Figure 6-4: Discharge Pusher
Before and After Adjustment
Figure 6-5: Discharge Pusher
Adjustment Wingnuts
Loosen the
side screws on
each pusher
plate to adjust
the position.