5-5
Verify that the temperature and high-limit probes are properly connected, tightened and
functioning properly, and that mounting hardware and probe guards are present and properly
installed.
Verify that component box and contactor box components (i.e. controller/controller, relays,
interface boards, transformers, contactors, etc.) are in good condition and free from oil and other
debris.
Verify that component box and contactor box wiring connections are tight and that wiring is in
good condition.
Verify that all safety features (i.e. contactor shields, drain safety switches, reset switches, etc.)
are present and functioning properly.
Verify that the frypot is in good condition and free of leaks and that the frypot insulation is in
serviceable condition.
Verify that all wiring harnesses and connections are tight and in good condition.
5.6.2 FilterQuick™
Filtration System
Inspect all oil-return and drain lines for leaks and verify that all connections are tight.
Inspect the filter pan for leaks and cleanliness. If there is a large accumulation of crumbs in the
crumb basket, advise the owner/operator that the crumb basket should be emptied into a fireproof
container and cleaned daily.
Verify that all O-rings and seals (including those on the quick-disconnect fittings) are present
and in good condition. Replace O-rings and seals if worn or damaged.
Check filtration system integrity as follows:
Verify that filter pan cover is present and properly installed.
With the filter pan empty, place each vat into fill vat from pan selection (see page 1-15 of the
FilterQuick manual), one at a time. Verify proper functioning of each oil return valve by
activating the filter pump using the fill vat from pan selection. Verify that the pump activates and
that bubbles appear in the cooking oil of the associated frypot only.
Verify that the filter pan is properly prepared for filtering, then drain a frypot of oil heated to a
setpoint above 300°F (149°C) (into the filter pan by using the drain to pan selection (see the
FilterQuick™ Controller Manual). Now using the fill vat from pan drain pan selection (see the
FilterQuick™ Controller Manual), allow all oil to return to the frypot (indicated by bubbles in
the cooking oil). Press the up arrow button when all oil is returned. The frypot should have
refilled in approximately 2 minutes and 30 seconds.
