A–1
FILTERQUICK™ FQE30 SERIES ELECTRIC FRYER
APPENDIX A: BULK OIL INSTRUCTIONS
A.1.1 Bulk Oil Systems
Bulk oil systems have large oil storage tanks,
typically located in the rear of the restaurant, that
are connected to a rear manifold on the fryer.
Waste oil is pumped from the fryer, via a fitting
located on the rear of the fryer labeled DISPOSE
(see Figure 1). , to the disposal tanks and fresh
oil is pumped from the tanks, thru the fitting
located on the rear of the fryer labeled FILL, to
the fryer (see Figure 2). Connect the bulk oil
connections to plug located on the rear of the
fryer (see Figure 3). The wiring diagram is
located on the next page.
It is imperative that the fryer system be
completely power cycled after changing any
fresh or waste oil settings.
Figure 1 Figure 2
Figure 3
The FilterQuick
™
fryers, equipped for use with
bulk oil systems, have an onboard fresh oil jug
supplied by the bulk oil provider. Remove the
cap and insert the standard fitting into the jug
with the metal cap resting on the lip of the jug.
The oil is pumped in and out of the jug through
the same fitting. (see Figure 4).
Figure 4
The momentary switch used to reset the ATO system
is also used to fill the jug in an fresh bulk oil system.
After clearing the TOP OFF EMPTY display,
pressing and holding the momentary switch, located
above the JIB, allows the operator to fill the jug from
the bulk oil storage tank (see Figure 5).
To fill the jug, press and hold the JIB reset button
until the jug is full, then
release.*
NOTE: Do NOT overfill the
jug.
For instructions on filling the
vat from bulk, see the
FilterQuick Controller Manual
Section 1.9.8 page 1-16.
* NOTE:
It takes approximately twelve seconds from the time the fill JIB button is pressed until the
fresh bulk oil pump starts. It may take up to 20 seconds before the level in the JIB begins to
rise. Typically it takes approximately three minutes to fill the JIB. It takes approximately
one minute to fill a split vat and two minutes to fill a full vat.
Fresh Oil
Connection
Waste Oil
Connection
WARNING:
Do not add HOT
or USED oil to a
JIB.
Bulk wiring
connection
Figure 5
