4-3
A FilterQuick™ controller controls the semi-automatic filtration system on the FilterQuick™ fryer.
After a preset number of cook cycles the controller displays
Filter now?
alternating with
YES NO
. If
NO
is selected or a cook cycle is started, the controller will resume normal operation
for a set amount of cooks and the prompt for a filter again. The FILTER NOW? prompt is displayed
once the cooks til filter or filter prompt count is satisfied. Refer to the FilterQuick™ controller
manual for filter steps. All messages need to be confirmed or cleared on all controllers prior to
starting any filtration process.
4.4 Troubleshooting
the
FilterQuick
™
with Fingertip Filtration
4.4.1 Incomplete
Filtration
Should the filter procedure fail after the filter paper or pad was changed an error message is
generated.
The controller displays
IS VAT FULL?
alternating with
yes no.
The MIB board displays three horizontal lines.
1. If the vat is full press the
(YES)
button to continue. The controller
returns to idle cook mode or OFF.
If the pot is not filled completely continue to next step.
2. Press
(NO)
if pot is not filled completely.
The controller displays
FILLING
while the pump runs again. When the pump stops, the controller
displays
IS VAT FULL?
alternating with
yes no
again. If the vat is full go to step 1. If the
vat is not completely filled continue.
3. Press
(NO)
if pot is not filled completely.
The controller displays
FILLING
while the pump runs again. When the pump stops, the controller
displays
IS VAT FULL?
alternating with
yes no
again. If the vat is full go to step 1. If the
vat is not completely filled continue.
4. Press
(NO)
if pot is not filled completely. If this is the sixth
consecutive sequence of incomplete filtration skip to step 8.
The controller displays
CHANGE FILTER PAPER?
alternating with
YES NO
and an
alarm.
5. Press
(YES)
to continue.
Pressing
(NO)
allows the fryer to return to cook mode in most cases for
four minutes or 15 minutes if the paper is expired*, ending with the
CHANGE FILTER PAPER?
alternating with
YES NO
display.
This repeats until
YES
is chosen.
