Terrazza Originale
Instructions for assembly
Version 5
12.06.2017
We reserve the right to make technical changes
Item number
111361-0000
Page 73/104
5.2.2 Fitting the gutter corner to a 90° post
Figure: Installing the roof gutter corner on the post
1
Corner connector
2
Gutter connector
Seal all the way round the joint. To do this, remove the corner connector from the gutter, fit
the gutter to the 90° post, then apply sealant to the corner connector and reinsert into the
gutter. Apply a suitable sealant to every abutting joint after each subsequent installation
step. Once sealed, the joints should be completely leak-tight.
Attach the 90° gutter connector to the guttering.
Affix the guttering to the post and seal.
Remove the nuts and washers from the loose ends of the clamps used for tensioning;
remove one of the grub screws from the post to make way for the second section of
guttering.
Slide the second section of guttering over the 90° gutter corner connector while also
inserting the loose ends of the tensioning clamps into the holes of the support angle.
Affix the guttering to the post and seal.
Affix the loose ends of the clamps complete with nuts and washers to the support angles.
Remove any excess adhesive and sealant.
Ø 8
Ø 6
M8x50
M6
M8
