Weichai America Corp.
77
5.
Check the clearance between the speed sensor and the gear unit of signal generator, it should
be (0.5-1.5) mm.
10.3
Electronic control module disassembly and assembly
10.3.1 Exploded view
1-Hexagon socket head cap screw; 2-ECU; 3-hexagonal flange bolt; 4-ECU bracket; 5-support
screw
Figure 10-5 Exploded view
10.3.2 Preparation before disassembly
Equipment conditions: pneumatic wrench, sleeve.
10.3.3 Dismantling
1.
Then disassemble the hexagon socket head cap screws on the ECU;
2.
Remove the ECU;
3.
Remove the hexagon flange bolts on the ECU bracket in turn;
4.
Remove the ECU bracket.
10.3.4 Installation
The assembly procedure is the opposite of the disassembly procedure.
Document Courtesy of Fly Parts Guy Co.
www.FlyPartsGuy.com
Document Courtesy of Fly Parts Guy Co.
www.FlyPartsGuy.com
