Weichai America Corp.
26
inlet pipe;
5.
Remove the oil and gas separator fixing bolts 12, remove the oil and gas separator;
6.
Remove the oil and gas separator bracket fixing bolt 2, Remove the oil and gas separator
bracket.
3.3.4 Oil and gas separator inspection and maintenance
1.
Check the appearance of the various components to see if there are any broken parts, cracks,
etc., and the failure modes of the hose hardened and cracked. If there is the above problem,
replace the corresponding parts;
2.
You can check whether the oil separator is smooth by inflating the inlet pipe of the pre-
separator. If the air flow is not smooth, you can pass the large pressure air to the pipe joints of
the separator to eliminate the impurities in the oil separator. Clean up and clear. If you do this,
the pre-splitter is still not clear and you will need to replace the new pre-splitter.
3.
You can check whether the oil separator is smooth by inflating the inlet pipe of the oil
separator. If the air flow is not smooth, you need to replace the new oil separator.
3.3.5 Oil and gas separator assembly steps
In contrast to the assembly and disassembly steps of the oil and gas separator, make sure that the
positions of the hoses and the connectors are correct according to Figure 4-16. At the same time,
pay attention to ensure the rotation angle when the hoses are installed and the fixed position is
consistent with the engine.
3.4
Lifting Lugs Assembly and Disassembly
3.4.1 Lifting Lugs Exploded View
Document Courtesy of Fly Parts Guy Co.
www.FlyPartsGuy.com
Document Courtesy of Fly Parts Guy Co.
www.FlyPartsGuy.com
