Weichai America Corp.
52
6.2
Intake pipe combination group disassembly and assembly
6.2.1 Exploded view
1 & 2 & 9, hexagonal flange bolts; 3, gasket; 4, flat washers; 5, spring washers; 6, hexagonal
head cap screws; 7, mixed intake manifold; 8, pressure and temperature sensors; ; 10, connector;
11, intake manifold assembly; 12, intake manifold gasket
Figure 6-2 Exploded view
6.2.2 Preparation before disassembly
Equipment conditions: pneumatic wrench, sleeve
6.2.3 Dismantling
Disassembly steps In contrast to the assembly procedure, recommended tightening torques for
intake pipe bolts are 23 N · m.
6.2.4 Installation
1.
Secure the temperature and pressure transducer (8) to the mixing inlet connector (7) with the
flange bolt (9) and tighten it with a wrench.
2.
Pass the spring washers (5) through the hexagon socket head cap screws (6). The flat washers
(4) will mix the intake manifold and the gasket (3) to the intake manifold assembly (11).
3.
Fix the intake pipe assembly to the cylinder head with hexagonal flange bolts (1) and (2).
Document Courtesy of Fly Parts Guy Co.
www.FlyPartsGuy.com
Document Courtesy of Fly Parts Guy Co.
www.FlyPartsGuy.com
