Lync AEGIS Controller
8: APPENDIX D
L-OMM-013_A
• 4/20/2022Technical Support • (800) 433-5654 • Mon-Fri, 8 am - 5 pm EST
84
of
100
page)
9561
R
Drop-off phase (visible only on the home
page)
9563
R
Interval phase between 2 defrost operations
(visible only on the home page)
16665
R
Type of Defrost (dynamic/fixed)
8975
R
Actual evaporation temperature
°C
9564
R
Defrost start evaporation temperature
°C
9580
R
Defrost request phase progress
%
9581
R
Defrost central phase progress
%
9582
R
Defrost drop-off phase progress
%
9583
R
Interval between two defrost cycles progress %
8.9.19. MENU - G CLOCK SET
On the main menu, with the G.CLOCK SET menu selected, press the RIGHT key to access
the screen used to set the date and time.
Select the different parameters with the UP and DOWN keys. Once the parameter has
been selected, press the OK key to edit the parameter.
When the parameter is in edit mode:
•
press the UP key to increase the value;
•
press the DOWN key to decrease the value;
•
press the BACK key to select the left box;
•
press the RIGHT key to select the right box;
•
press the OK key to exit the
parameter’s edit mode.
Once the values have been edited press the UPDATE key and then OK to confirm the setting.
8.9.20. MENU - H SERVICE
On the main menu, with the H.SERVICE menu selected, press the RIGHT key to access the
screens that require the
“service” password to be entered for access to the maintenance
operator’s parameters (see below).
8.9.21. MENU - I MANUFACTURER
On the main menu, with the I.MANUFACTURER menu selected, press the RIGHT key to
access the screens that requir
e the “Manufacturer” password to be entered for access to the
manufacturer’s parameters. Access is allowed only to the manufacturer's personnel.
