52
Lara | Instructions for Use | RIL-1 W&H Med ENG Rev06 | 14/04/2022 | © W&H Sterilization Srl
Sterilization cycles
2
Check the cycle requirements.
3
Check the icon in the top left corner of the page to know the
drying mode assigned to the cycle.
4
Tap
to disable the drying mode (see "Set the drying time"
5
If the door gasket is new, hold the door gently closed until step
7.
6
Tap and enter your credentials if required: the door locks. If
you have not set a different start time, the sterilization starts
immediately.
7
Wait the end of the sterilization. Tap to view the cycle
parameters in real time. See "View the cycle parameters" on the
next page.
8
The sterilization is completed. Tap
to view the cycle
summary or tap to view the cycle information. See "View the
cycle parameters" on the next page.
9
Tap
OPEN
: the door unlocks.
10
If required, enter your credentials and confirm the release of
the load if needed.
SET THE STERILIZATION CYCLE START
You may schedule the start of the sterilization cycles at a certain
date and time (e.g., if you want to load the sterilizer in the evening
and run standard sterilization cycle early the next morning before
office hours). You can set the cycle start date and time and enable or
disable it for each cycle.
1
On the homepage, tap the cycle.
2
To change the start time, tap
Start cycle at
.
3
Tap the time or the date: a settings page opens.
4
Tap the number you want to change and tap
or
to
increase it or decrease it.
5
Tap to confirm and go back to the previous page.
6
Tap
to lock the door and start the countdown for the current
cycle.
Note
: You can decide to start the cycle immediately or stop the
countdown at any time.
